1. INSTALLATION
1.1 Check and make sure that the following accessories
are included:
This operation manual
Scale x 1
Plastic platter x 1
Stainless steel cover x 1
Screw x 1
Rubber cap x 1
Power adaptor x 1
Contact your dealer if any item is missing.
FIG 1
FIG 2
1.2 Locks the plastic platter (FIG 1 A) to the platter
holder, with the screw (FIG 1 B) included, and then
apply the screw rubber cap (FIG 1 C).
1.3 Place the stainless steel platter (FIG 1 D) onto
the plastic platter.
1.4 Power on the scale
a. Before charging the scale or power on with the
adaptor supplied. Please make sure the input
voltage listed on the back of the adaptor matches
with the local voltage. If not, do not use it
and contact your dealer immediately.
To Next Page
Loading...
