UWE W75 Series - Internal Functions

4. INTERNAL FUNCTION
Because of metrological legislation, accessing to some internal functions is limited to authorized
person only when this unit is set to legal for trade. DO NOT try to open the scale or manipulate with
the hardware seal when the unit is metrological approved. Please contact your dealer for more
information. All internal functions are listed below, some are restricted for dealers only.
DISPLAY
FUNCTION SETTING
ACCESS CONDITION
F 0
Zero tracking range
Dealer only when LOCKED
F 1
1. Analog to digital offset value
2. Function key test
Open
F 2
1. LCD segment check and software version information
2. Adjusting backlight brightness
Open
F 3
Scale configuration setup
Dealer only when LOCKED
F 4
Auto power off
Dealer only when LOCKED
F 5
Transmission protocol for RS-232/RS-485
Open
F 6
1. Digital motion filter
2. Animal weighing
Open
F 7
transmission mode & data format for RS-232/RS-485
Open
F 9
Auto tare
Open
F 16
Turning on/off real time clock
Open
F 17
Time and date setup
Open
F 18
Buzzer sound
Open
F 20
Manufacturing site gravity value setup
Dealer only when LOCKED
F 21
Final destination gravity value setup
Dealer only when LOCKED
F 38
Backlight timing
Open
F 99
High resolution verification mode
Dealer only when LOCKED
F 100
Reset to factory default
Dealer only when LOCKED