Vacon NXI Series - Monitoring Menu (M1)

control keypad vacon • 51
24-hour support: +358-(0)40-8371 150 • Email: vacon@vacon.com
7
7.3.1 Monitoring menu (M1)
You can enter the Monitoring menu from the Main menu by pressing Menu button right when the
location indication M1 is visible on the first line of the display. Figure 3-1 shows how to browse
through the monitored values.
The monitored signals carry the indication V#.# and they are listed in Table 7-1. The values are
updated once every 0.3 seconds.
This menu is meant only for signal checking. The values cannot be altered here. For changing values
of parameters, see Chapter 7.3.2.
Figure  7-3 Monitoring menu
Code
Signal name
Unit
Description
Output frequency
Hz
Frequency to the motor
Frequency reference
Hz
Motor speed
rpm
Calculated motor speed
Motor current
A
Measured motor current
Motor torque
%
Calculated actual torque/nominal torque of the unit
Motor power
%
Calculated actual power/nominal power of the unit
Motor voltage
V
Calculated motor voltage
DC-link voltage
V
Measured DC-link voltage
Unit temperature
ºC
Heat sink temperature
Motor temperature
%
Calculated motor temperature
Voltage input
V
AI1
Current input
mA
AI2
DIN1, DIN2, DIN3
Digital input statuses
DIN4, DIN5, DIN6
Digital input statuses
DO1, RO1, RO2
Digital and relay output statuses
Analogue output
current
mA
AO1
M1.17
Multimonitoring items
Displays three selectable monitoring values. See
chapter 7.3.6.5.
Table 7-1. Monitored signals
Note! All in One applications may embody more monitoring values.
V1èV14
READY
Local
13.95 Hz
READY
Local
13.95 Hz
READY
Local
RUN RUN
RUN
Monitor Output frequency
FreqReference