Figure
7-9. Parameter comparison
7.3.6.5
Safety
NOTE: The
Security submenu
is protected with a password. Store the password in a safe place!
Password (S6.5.1)
The application selection can be protected against unauthorised changes with the Password function
(S6.5.1).
By default, the password function is not in use. If you want to activate the function, enter the edit
mode by pressing
Menu button right
. A blinking zero appears in the display and you can set a
password with the
Browser buttons
. The password can be any number between 1 and 65535.
Note that you can also set the password by digits. In the edit mode, push
Menu button right
again
and another zero appears on the display. Set ones first. To set the tens, press
Menu button right
, and
so on. Confirm the password with the
enter
button. After this, you have to wait until the
Timeout time
(P6.6.3) (see page 73) has expired before the password function is activated.
If you try to change applications or the password itself, you will be prompted for the current
password. Enter the password with the
Browser buttons
.
You can deactivate the password function by entering the value 0.
Figure
7-10. Password setting
Note! Store the password in a safe place! No changes can be made unless a valid password is
entered.
To Next Page
Loading...
