Figure
7-19. HMI acknowledge timeout
Number of retries to receive HMI acknowledgement (P6.7.4)
With this parameter you can set the number of times the drive will try to receive acknowledgement if
it does not receive acknowledgement within the acknowledgement time (P6.7.3) or if the received
acknowledgement is faulty.
You can change value through the same procedure as for P6.7.3 (see above).
Note! Changes to P6.7.3 and P6.7.4 become effective after the next start-up.
7.3.6.8
System info
In the System info submenu (S6.8) you can find inverter-related hardware and software information.
You can enter the
System info submenu
by pressing
Menu button right
. You can now browse the
submenu pages with the
Browser buttons
.
Total counters
The
Total counters menu
(S6.8.1) contains information on the inverter operation times i.e. the total
number of MWh, operation days and operation hours. Unlike the counters in the Trip counters menu,
these counters cannot be reset.
Note! The Power On time counter (days and hours) runs always when the power is on.
To Next Page
Loading...
