Vacon NXI Series - Page 79

control keypad vacon • 77
24-hour support: +358-(0)40-8371 150 • Email: vacon@vacon.com
7
Trip counters
Trip counters (menu S6.8.2) are counters the values of which can be reset i.e. restored to zero. You
can use the following resettable counters:
Note! The trip counters run only when the motor is running.
Page
Counter
T6.8.2.1
MWh counter
T6.8.2.3
Operation day counter
T6.8.2.4
Operation hour counter
Table  7-6. Resettable counters
The counters can be reset on pages 6.8.2.2 (Clear MWh counter) and 6.8.2.5 (Clear Operation time
counter) .
Example: When you want to reset the operation counters you should do the following:
Figure  7-20. Counter reset
Software (S6.8.3)
The Software information page includes information on the following inverter software related topics:
Page
Content
6.8.3.1
Software package
6.8.3.2
System software version
6.8.3.3
Firmware interface
6.8.3.4
System load
Table  7-7. Software information pages
Applications (S6.8.4)
At location S6.8.4, you can find the Applications submenu containing information on the application
currently in use and all other applications loaded into the inverter. The following information is
available:
Page
Content
6.8.4.#
Name of application
6.8.4.#.1
Application ID
6.8.4.#.2
Version
6.8.4.#.3
Firmware interface
Table  7-8. Applications information pages
T1èT5
READY
READY READY
enter
READY READY
STOP
STOP
STOP STOP
READYSTOP
Trip counters
Clr Optime cntr Clr Optime cntr
Not reset Not reset
Clr Optime cntr
Reset
Clr Optime cntr
Reset
Clr Optime cntr
Not reset