Figure
7-7. Storing and loading of parameter sets
Upload parameters to keypad (To keypad, S6.3.2)
This function uploads all
existing parameter groups to the keypad provided that the drive is stopped.
Enter the
To keypad
page (S6.3.2) from the
Parameter copy menu
. Pressing
Menu button right
takes
you to the edit mode. Use the
Browser buttons
to select the option
All parameters
and press the
enter
button. Wait until 'OK' appears on the display.
Figure
7-8. Parameter copy to keypad
Download parameters to drive (From keypad, S6.3.3)
This function downloads one or all parameter groups uploaded to the keypad to a drive provided that
the drive is in STOP status.
Enter the
To keypad
page (S6.3.2) from the
Parameter copy menu
. Pressing the
Menu button right
takes you to the edit mode. Use the
Browser buttons
to select either
All parameters, All but motor
parameters
or
Application parameters
and press the
Enter button
. Wait until 'OK' appears on the
display.
The procedure to download the parameters from keypad to drive is similar to that of from drive to
keypad. See Figure 7-8.
To Next Page
Loading...
