Vacon OPTE9 User Manual

Using the Add-On Instruction (AOI) vacon • 15
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
4
4) Select the correct EDS file according to the used setup and click “Create”.
a. In this example, the VACON
®
NXP drive is used with an OPTE9/A option board.
5) Give the module a name. In this example, “VACON_1” is used.
6) Give the module a valid IP address. The IP address must be same as what was
configured for OPTE9/A (see Chapter 2.1).
7) Click “Change”.
8) Change the module definition to use assembly instances 21/71.
a. This should be selected to be the same as what the AOI is using. In this
example, it is VACON_DRIVE_21_71.

Vacon OPTE9 Specifications

General

Brand	Vacon
Model	OPTE9
Category	Network Router
Language	English