Operation 4
0020237615_01 multiMATIC Operating instructions 9
The display shows an element that is highlighted by white
writing on a black background. A flashing, highlighted value
means that you can change the value.
If you do not operate the control for more than 10 seconds,
the background lighting switches off.
If you do not operate the control for more than 60 seconds,
the control becomes inoperative and dashes (--) appear on
the display instead of values.
If you do not operate the controller during a period of more
than 5 minutes, the basic display appears again.
4.3.1 Using the rotary knob to make settings in
the basic display
If the display shows the basic display, you can use the rotary
knob to change the desired setting.
The setting that you change depends on the selected basic
display, operating mode and the set mode for the operating
mode.
4.3.1.1 Changing the desired setting in the Heating
operating mode
OK
Desired day temperature
Only today: 18 °C
For long-term change,
press OK
Mode Time
periods
Effect
Auto On Switch to another display view with the
request:
– Permanent change to the Day
temp. heating
– Change to the Day temp. heating
for six hours
Off Direct change to the Set-back temp.
heat. for six hours
Day Switch to another display view with the
request:
– Permanent change to the Day
temp. heating
– Change to the Day temp. heating
for six hours
Set-back Direct change to the Set-back temp.
heat. for six hours
off None
4.3.1.2 Changing the desired setting in the Cooling
operating mode
Mode Time
periods
Effect
Auto On Direct permanent change to the Day
temp. cooling
Off None
Day Direct permanent change to the Day
temp. cooling
off None
4.3.1.3 Changing the desired setting in the
Ventilation operating mode
Mode Time
periods
Effect
Auto On Direct permanent change to the Max.
vent. stage: Day
Off Direct permanent change to the Max.
vent. stge: Night
Day Direct permanent change to the Max.
vent. stage: Day
Set-back Direct permanent change to the Max.
vent. stge: Night
4.3.1.4 Changing the desired setting in the Manual
cooling advanced function
Mode Time
periods
Effect
Activated On Direct permanent change to the Day
temp. cooling
Off None
4.3.1.5 Using the rotary knob to make settings with
no effect
You cannot influence the following advanced functions by
turning the rotary knob:
– System OFF active
– Cylinder boost
– Party function
– 1 day at home
– Days at home scheduling
– 1 day away from home
– Days away from home scheduling
– Ventilation boost
– Screed-drying function
To Next Page
Loading...
Need help?
General
