Installation and maintenance instructions for uniSTOR 0020111105_00 3
1 Notes on the documentation
The following instructions are intended to guide you
through the entire documentation. Other documents
apply in addition to these operating instructions.
We do not accept liability for any claims or damages
resulting from failure to observe these instructions.
1.1 Other applicable documents
> When installing the cylinder, you must pay attention to
the installation instructions for components of the sys-
tem.
These installation instructions are enclosed with the var-
ious system components as well as additional compo-
nents.
> You must also observe all operating instructions included
with the system components.
1.2 Storing documents
> Pass these installation instructions and all other appli-
cable documents and, if necessary, any required tools to
the system operator.
The system operator will store these so that they are
available when required.
1.3 Symbols used
The symbols used in the text are explained below.
a
Symbol that denotes danger:
– Imminent danger to life
– Risk of severe personal injury
– Risk of minor personal injury
e
Symbol that denotes danger:
– Risk of death from electric shock
b
Symbol that denotes danger:
– Risk of material damage
– Risk of damage to the environment
i
Symbol that denotes useful tips and
information
> Symbol for a required action
1.4 Applicability of the instructions
These installation instructions are valid exclusively for
units with the following article numbers:
Unit type Cylinder volume Article number
VIH GB 120/2 S 120 litres 0020115403
VIH GB 155/2 S 155 litres 0020115406
VIH GB 180/2 S 180 litres 0020115409
VIH GB 210/2 S 210 litres 0020115412
VIH GB 260/2 S 260 litres 0020115415
VIH GB 310/2 S 310 litres 0020115418
Table 1.1 Applicability of the instructions
> The article number of the unit is displayed on the identi-
fication plate.
1.5 Cylinder identification plate
The identification plate is attached to the front of the
cylinder at the factory.
1.6 CE label
CE labelling shows that, based on the type overview,
the units comply with the basic requirements of the
following directives:
– Low voltage directive (Council Directive 2006/95/EC)
– Electromagnetic compatibility directive (Council Directive
2004/108/EC)
Notes on the documentation 1
To Next Page
