Installation and maintenance instructions for uniSTOR 0020111105_00 7
EC low voltage directive 2006/95/EC
Directive 2006/95/EC of the European Parliament and
Council of 12th December 2006 on the harmonisation of
the laws of Member States relating to electrical equip-
ment designed for use within certain voltage limits
Lightning protection
ENV 61024-1
Protection of structures against lightning –
Part 1: General principles (IEC 1024-1: 1990; modified)
BS 6651: Code of practice for protection of structures
against lightning
2.5 Regulations for Great Britain
2.5.1 Technical Guidance
This appliance must only be installed and commissioned
by a suitably competent person. Please check with your
installer that he is able to carry-out all the necessary
works including official notification of the works to the
relevant body upon completion.
The system must be installed in accordance with all rele-
vant and applicable national regulations, and must be
installed to suit site conditions.
Observe all national regulations, including:
– Working at Heights Regulations 2005
– Health and Safety at Work Act 1974
– Electricity at Work Regulations 1989
– IEE Wiring Regulations BS 7671
– Lightning protection requirements
– Equipotential bonding of electrical installations.
2.5.2 Related documents
The installation of the appliance and any associated hot
water system must be in accordance with (but not lim-
ited to) the following; COSHH regulations, Gas Safety
(Installation and Use) Regulations 1998, Health and
Safety Document No. 635 (The Electricity at Work Regu-
lations 1989), BS7671 (IEE Wiring Regulations) and the
Water Supply (Water Fitting) Regulations 1999, or
The Water Bylaws 2000 (Scotland). It should also be in
accordance with the relevant requirements of the Local
Authority, Building Regulations, The Building Regulations
(Scotland), The Building Regulations (Northern Ireland)
and the relevant recommendations of the following
British Standards:
BS 6700: Services supplying water for domestic use
within buildings and their curtilages.
BS 6798: Specification for installation of gas fired boil-
ers not exceeding 60 kW input.
BS 6891: Specification for installation of low pressure
gas pipework up to 28 mm (R1) in domestic premises
(2nd family gas).
BS 7593: Treatment of water in domestic hot water cen-
tral heating systems. Institute of Gas Engineers Publica-
tion IGE/UP/7/1998: ”Guide for gas installations in tim-
ber framed housing”
BS. 5482 Pt. 1 Domestic butane and propane gas burn-
ing installations.
IGE/UP1 Soundness testing and purging of industrial
and commercial gas installation.
IGE/UP2 Gas installation pipework, boosters and com-
pressors on industrial and commercial premises.
IGE/UP10 Installation of gas appliances in industrial and
commercial premises.
BS. 6644 Installation of gas fired hot water boilers of
rated inputs between 60 kW and 2 MW (2nd and 3rd
family gases).
BS. 5449 Forced circulation hot water central heating
systems for domestic premises. Note: only up to 45 kW.
BS. 6880 Low temperature hot water heating systems
of output greater than 45 kW.
Part 1 Fundamental and design considerations.
Part 2 Selection of equipment.
Part 3 Installation, commissioning and maintenance.
BS. 4814 Specification for: Expansion vessels using an
internal diaphragm, for sealed hot water heating sys-
tems.
BS. 5440 Installation and maintenance of flues and
ventilation for gas appliances of rated input not exceed-
ing 70 kW net (1st, 2nd and 3rd family gases).
Part 1 Specification for installation of flues.
Part 2 Specification for installation and maintenance
of ventilation for gas appliances.
Safety instructions and regulations 2
To Next Page
Loading...
Need help?
General
