Need help?Do you have a question about the Vaisala HMD65 and is the answer not in the manual?
General| Humidity Measurement Range | 0 to 100 %RH |
|---|---|
| Enclosure Rating | IP65 |
| Display | No display |
| Measurement Parameters | Relative Humidity, Temperature |
| Output Signal | 4 to 20 mA / 0 to 1 V / RS-485 |
| Power Supply | 10 ... 35 VDC |
| Humidity sensor | Vaisala HUMICAP® |
Details key features, measurement capabilities, and output options.
Step-by-step instructions for physically mounting the transmitter in a duct.
Illustrates the analog and digital output wiring connections.
Introduction to the configuration software for Indigo-compatible devices.
Steps for establishing a connection between the transmitter and Insight software.
Overview of the main interface and navigation within Insight software.
How to set up analog output channels for RH and T measurements.
Procedure for calibrating analog voltage outputs.
Setting error limits for RH and T measurements.
Introduces Modbus RTU and BACnet MS/TP communication protocols.
How to configure communication settings using Insight software.
Introduction to the M170 hand-held indicator for service tasks.
Steps for connecting the HMD60 transmitter to the M170 indicator.
Outlines the methods for calibrating and adjusting the transmitter.
Detailed steps for using physical trimmers for calibration.
Calibrating using trimmers with a reference calibrator.
Calibrating using trimmers with a reference transmitter.
How to reset trimmers to their zero point using Insight PC software.
Procedure for calibrating using the Insight PC software.
Performing a two-point calibration with a reference calibrator.
Performing a one-point calibration with a reference transmitter.
Calibrating using the M170 indicator.
Steps for a one-point adjustment using a reference environment.
To Next Page
