Need help?Do you have a question about the Vaisala HMD60 Series and is the answer not in the manual?
General| Measurement Parameters | Humidity and Temperature |
|---|---|
| Measurement Range (Humidity) | 0 to 100 %RH |
| Protection Class | IP65 |
| Output Signal | 4 to 20 mA, 0 to 1 V |
| Power Supply | 10 to 30 VDC |
| Operating Temperature Range | -40 to +60 °C |
| Storage Temperature Range | -40 to +70 °C |
Explains how to connect the transmitter to Vaisala Insight software for configuration and monitoring.
Explains the function and use of the RH and T adjustment trimmers on the component board.
Guides on how to mount the transmitter in a duct, including placement and clearance.
Provides step-by-step instructions for drilling holes and mounting the transmitter into a duct.
Provides steps to connect the HMD65 transmitter to the Insight PC software.
Guides on configuring analog output channels for humidity and temperature measurements using Insight.
Details how to test and adjust analog output voltage levels using Insight and a multimeter.
Explains how to define error limits for RH and T measurements within the Insight software.
Provides an overview of Modbus RTU and BACnet MS/TP communication options for HMD65.
Describes how to configure Modbus and BACnet settings using Vaisala Insight PC software.
Explains how to configure various BACnet settings like Max_Master and Device Object Name via Insight.
Provides steps to connect the HMD60 transmitter to the M170 indicator using a connection cable.
Lists the available methods for calibrating and adjusting the transmitter's measurement output.
Describes how to perform 1-point adjustments using the RH and T trimmers on the transmitter board.
Provides steps for 1-point adjustment using trimmers and a reference calibrator.
Details how to perform 1-point adjustment using trimmers and a reference transmitter.
Explains how to reset the trimmers to their zero point using the Insight PC software.
Guides on calibrating and adjusting RH or T measurements using the Insight PC software.
Outlines the procedure for 2-point adjustment using Insight and a reference calibrator.
Describes how to perform 1-point adjustment using Insight and a reference transmitter.
Explains how to perform 1-point adjustment using the M170 hand-held indicator.
Details 1-point adjustment using a reference environment and the M170 indicator.
Lists the detailed specifications for relative humidity and temperature measurement performance.
To Next Page
