Need help?Do you have a question about the Vaisala HMD62 and is the answer not in the manual?
General| Humidity Measurement Range | 0 to 100 %RH |
|---|---|
| Protection Class | IP65 |
| Weight | Approx. 200 g |
| Measurement Parameters | Relative humidity, Temperature |
| Output Signal | 0 to 1 V, 0 to 10 V, or 4 to 20 mA |
| Power Supply | 10 to 35 VDC |
| Response Time | 15 s (90 % at +20 °C still air) |
| Humidity Sensor | Vaisala HUMICAP® |
Explains the function and adjustment range of RH and T trimmers on the board.
How to select humidity output parameters using DIP switches on the HMD62.
Step-by-step instructions for physically installing the transmitter into a duct.
Wiring diagrams and instructions for connecting the HMD62 and TMD62 transmitters.
Overview of the different methods for calibrating and adjusting transmitter output.
Instructions for 1-point adjustment using the physical trimmers on the transmitter board.
Procedures for 1-point or 2-point adjustment using Vaisala Insight software.
Steps for performing 1-point adjustment using the M170 hand-held indicator.
How to configure analog output settings for the transmitter using Insight software.
Setting error limits for RH and T measurements in Insight to trigger error states.
Adjusting pressure compensation values for HMD62 measurements using Insight.
Configuring the filtering factor for measurement output using Insight software.
To Next Page
