Vaisala PTB220 Series - Software Settings; SERI: Serial Bus Settings

USER'S GUIDE_______________________________________________________________________
16 ___________________________________________________________________ M210194EN-A
Software settings
SERI Serial bus settings
SERI b p d s x <cr>
where: (* = factory setting)
b = baud rate (300, 600, 1200, 2400, 4800, 9600*)
p = parity (E = even*, O = odd, N = none)
d = data bits (7* or 8)
s = stop bits (1* or 2)
x = duplex (F = full* or H = half)
<cr> = carriage return is generated by the ENTER or RETURN
key of the host computer
The SERI command is used to set or inspect the serial bus settings of
the barometer.
Examples:
>seri <cr>
9600 E71F
>seri 1200N81H<cr>
1200 N81H
>reset <cr>
PTB220 / 2.02
>seri 2400 <cr>
2400 N81H
>seri F <cr>
2400 N81F
>reset <cr>
PTB220 / 2.02
>
Always give the RESET command after the SERI command to
activate the new serial bus settings.
The following bus settings do not work with the incorporated Intel
8051 microprocessor. They are modified by the barometer:
N 7 1 → N 7 2
E 8 2 → E 8 1
O 8 2 → O 8 1