7
EN
Using the appliance
B
Using your dishwasher
Before using your dishwasher:
1. Set the water softener.
2. Add salt to the water softener
3. Load the rack
4. Fill the container
Interior Exterior
PLEASE NOTE
You can refer to the "water softener" section if you need to
adjust the water softener.
Adding salt to the water softener:
If your model does not have a water softener, you can skip this section. Always use salt that
is intended for use in a dishwasher.
The salt container is located under the lower rack and should be filled as described below:
WARNING
• Only use salt specifically for use in dishwashers!
• Any other type of salt that is not specifically for use
in a dishwasher, especially table salt, will damage the
water softener. In the event of damage caused by the
use of unsuitable salt, the manufacturer will decline
any warranty claim and may not be held liable for the
damage caused.
• Wait until you are ready to start a wash cycle before
filling the salt container.
• This will prevent any grains of salt or salt water
that may have been spilled and left at the bottom of the
machine for any length of time from causing corrosion.
To Next Page
Loading...
Need help?
General
