27
EN
Using the appliance
B
Starting a wash cycle
1. Pull out the upper and lower racks, load the tableware and then push them back in. It
is recommended to load the lower rack first and then the upper rack.
2. Add detergent.
3. Insert the plug into the socket. For more information on the power supply, refer to the
“Product Sheet” on the last page. Ensure that the water supply is open at full pressure.
4. Open the door, press the power button.
5. Choose a programme, the corresponding indicator will light up. Then close the door
and the dishwasher will start the wash cycle.
Changing the programme during a cycle
A wash cycle can only be changed if it has recently started. If the cycle has progressed further,
the detergent may have already been released and the machine may have already drained the
wash water. If this occurs, the dishwasher will need to be reprogrammed and the detergent
dispenser refilled. To reprogram the dishwasher, follow the instructions below:
1. Open the door slightly to stop the dishwasher. Once the wash arm has stopped working,
you can open the door fully.
2. Press and hold the “Programmes” button for more than three seconds to pause the
machine.
3. You can then change the programme to the desired cycle.
To Next Page
Loading...
Need help?
General
