EasyManuals Logo

VALBERG 14S42 C XAD929C User Manual

VALBERG 14S42 C XAD929C
175 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
11
EN
Using the appliance
B
A 20A circuit breaker or a 16A fuse on the appliance’s dedicated circuit must be used.
The cross-section of the supply cables must be 2.5 mm² and the differential switch, 30 mA.
The outlet must be equipped with a protective ground plug. If the plug is unsuitable or
damaged, replace it and check the electrical installation to ensure that it meets the above
requirements.
WATER INLET AND OUTLET
Cold water connection
Connect the cold water supply hose to a 1.9 cm threaded fitting and ensure that it is
tight.
If the water supply pipes are new or have not been used for a long time, let the water run
to check it is clear. This is required to avoid the risk of the water supply being blocked,
which could damage the appliance.
CAUTION
A hose connected to a spray tap can burst if it is installed
on the same water pipe as the dishwasher. If your sink is
equipped with one, it is recommended disconnecting the
pipe and blocking the hole.
How do I disconnect the safety inlet hose?
1. Close the water supply.
2. Unscrew the safety inlet hose from the tap.
CONNECTING THE DRAIN HOSES
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run
into the sink, being careful to avoid bending or pinching the hose. The height of the drain

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VALBERG 14S42 C XAD929C and is the answer not in the manual?

VALBERG 14S42 C XAD929C Specifications

General IconGeneral
BrandVALBERG
Model14S42 C XAD929C
CategoryDishwasher
LanguageEnglish

Related product manuals