12
EN
Using the appliance
B
pipe should not exceed 1000 mm. To avoid backflow, the free end of the hose should not
be submerged in water.
• Ensure that the drain hose is securely fastened either in position A or position B.
Back of the dishwasher
Drain hose
Worktop
Water inlet
Drain hose
Power cord
Draining excess water from hoses
• If the sink is more than 1000 mm above the floor, excess water from the hoses cannot be
drained directly into the sink. It will be necessary to drain it into a bowl or other suitable
container that is lower than the sink.
Water outlet
• Connect the drain hose. Ensure it is securely attached to prevent water leakage. Check
the drain hose is not twisted or crushed.
Hose extension
• If you need a drain hose extension, make sure you use the same type of hose. It should
not be longer than 4 metres, otherwise the cleaning performance of your dishwasher
may be reduced.
Connecting the siphon
• The waste water connection must be less than 100 cm (maximum) from the bottom of
the tub. The water drain hose must be attached.
To Next Page
Loading...
Need help?
General
