INSTALLER GUIDE
Page 35
© Baxi Heating U.K. Limited 2008.
17.4 To remove the fascia.
1. Remove the ash pan casting.
2. Remove the two screws and washers securing the
bottom of the fascia to the sides of the convection box
(See figure 34).
3. Carefully lift the fascia upward to clear the upper
retaining brackets on the convection box. Pull the
fascia clear and place carefully aside.
4. Refit in the reverse order. Make sure that the fascia
is properly located over the upper retaining brackets.
See section 15 of this guide for detailed fitting
instructions.
17.5 To replace the control slide unit.
1. Remove the fascia (See section 17.4).
2. Remove the knurled screw securing the control linking
arm to the burner (See figure 35).
3. Detach the slide unit by removing two screws securing it
to the convection box flange (See figure 36).
4. Replace in the reverse order.
17.6 To replace the control slide button.
1. Remove the fascia (See section 17.4).
2. Unscrew and remove the two screws securing the slide
button to the slider mechanism.
3. Remove the button, replace and fit in the reverse order.
Figure 36. Slider
mechanism removal
Figure 35. Control linkage
disconnection
To Next Page
