• Engage the parking brake:
Stop the tractor completely. Pull up the collar round the power shuttle lever
and move the lever to the parking brake (P) position.
GUID-C8DBFD22-64C1-4BCB-B3E6-5FCFD5184ECD
1. Power shuttle lever
2. Collar
The parking brake indicator light
on the instrument panel and the P
symbol on the A-pillar display are lit. If the indicator light is flashing, the
engagement of the parking brake is delayed.
The parking brake engages when driving speed is approximately 3 km/h or
lower. If you move the power shuttle lever to the P position at higher driving
speeds, the P symbol flashes on the A-pillar display until the speed drops
below the limit.
DANGER: Apply the parking brake when you park the tractor. The
tractor may still move if the parking brake is not applied, even if
the tractor is parked and power is turned off.
WARNING: The parking brake indicator light
flashes or
message “PARKING BRAKE FAULT!” is shown on the instrument
panel display if there is a fault in the parking brake system. In
addition the buzzer alarms continuously. The parking brake might
not function properly. Park the tractor on level ground and repair
the fault before continuing to drive.
• Disengage the parking brake:
Pull up the collar round the power shuttle lever and move the lever away from
the parking brake (P) position to the neutral (N) position. If the indicator light
is flashing, the disengagement of the parking brake is delayed.
• Select the desired driving direction:
Move the power shuttle lever to the forward (F) or reverse (R) driving
direction. Change the driving direction at lower driving speeds with high load
so that there is less stress on the power transmission.
3. Operation
- 103 -
To Next Page
Loading...
Need help?
General
