VAMP 140 - Communication Protocol Configuration

VAMP 140 Overcurrent and earth-fault relay
Operation and Configuration
VAMP Ltd
24
Vamp 24h support phone +358 (0)40 573 6316 VM140.EN011
5.8. Configuring communication protocols
COM
Via the submenus of the COM menu the following functions
can be read and set:
Active
• Communication protocol of REMOTE port (Protocol)
• Message counter (Msg#)
• Communication error counter (ERRORS)
• Communication time-out counter (Tout)
Profibus
• Profibus profile (Mode)
• Transfer rate of converter
• Profibus Tx Buf lentgh (InBuf)
• Profibus Rx Buf lentgh (OutBuf)
• ProfiBus address (Addr)
• Type of the ProfiBus converter (Conv)
ModBus
• Device slave number at ModBus Slave Protocol or
target slave number at ModBus Master protocol (Addr)
• ModBus transfer rate (bit/s)
• ModBus parity check (Parity)
SpaBus
• Slave number (Addr) when relay connected to SPA-Bus
• SPA-Bus transfer rate (bit/s)
• Event mode (Emode)
IEC-103
• Slave address (Addr)
• Transfer rate (bit/s)
TCP/IP (ModBus TCP, only in VAMPSET)
• IP address of the relay (IPAddr)
• Subnet mask (NetMsk)
• IP address of the Name Server (NameSv)
• IP address of the SNTP Server (NTPSvr)
• IP address of the Gateway (Gatew)
• IP port number for Protocol (Port)
Local Port
• Transfer rate of local serial bus (bit/s)