Vanatoo TRANSPARENT ONE ENCORE - Adjusting Treble and Bass; Adjusting Power On LED Brightness; Audio Music Source Precedence

www.vanatoo.com 11
ADJUSTING TREBLE AND BASS
ThetrebleandbasscanbeadjustedontheT1Eusingthetrebleandbassknobslocatedon
thebackoftheT1Eactivespeaker.Notethatboththetrebleandbasscontrolshaveadetent
atthe12o’clockposition.Thisdetentpositionisthe“at”positionforthetonecontrol.
ADJUSTING THE BRIGHTNESS OF THE POWER ON LED
TheintensityofthebluepoweronLEDcanbeadjustedtotaste.Infactitcanbeturnedo
completelyifyouwant.ToadjusttheintensityoncetheT1Esarepoweredupandtheblue
LEDisonandnomusicisplaying,holdthe“Pair-Prog”buttondownfor5seconds.Afterthe
5secondscontinuetoholdthebuttondown(donotreleaseitoryouwillhavetostartthe5
secondsoveragain).Thenrotatethevolumeknob.WhenyouhavetheblueLEDintensity
whereyoulikeitthenreleasethePair-Progbutton.That’sit.Nomoreneedofapieceofblack
electricaltapestuckonthepoweronLEDtokeepyourbedroomdark.TheblueLEDwillnow
beatthisintensityuntilyouchangeit.
TIP
WhenyouhavecompletedtheLEDintensityprocessbyreleasingthePair/Progbutton
remembertoreadjustyourvolumeknobtoyourdesiredlisteninglevel.Ifyouadjustyour
LEDintensitytoaverylowintensitythenforgettoreadjustyourvolumeknobwhenyou
aredoneyoumightwonderwhyyoucannolongerhearyourmusic.
AUDIO MUSIC SOURCE PRECEDENCE
IfyouhaveyourT1Esettoautoinputswitching(thisisthedefaultsetting)andmultiple
devicesareconnectedtoyourT1Espeakers,thedeviceyouhearisautomaticallyselected
basedonthehierarchyshownbelow:
1. Analog
2. AudioUSB
3. OpticalS/PDIF
4. Coax
5. Bluetooth
Forexample,iftheT1EisconnectedtoanMP3playerviathe3.5mmanalogconnectionand
toanetworkedaudiodeviceviatheTOSLINKopticalconnection,andbothareturnedon,the
MP3playeristhesourcethatwillbeplayed.Ifhowever,theMP3playeristurnedoandthe
networkedaudiodeviceislefton,thenetworkedaudiodevicewillbethesourcethatisplayed.
When switching from a higher priority input to a lower priority input, the higher priority
input must be OFF (or silent) for 7 seconds before the T1E amplier will switch to the
lower priority input. Thisenablestheampliertodiscernbetweenthehigherinputbeing
turnedoandnormalinter-tracksilencethusavoidingswitchingtothelowerpriorityinput
betweenaudiotracks.This7secondwaittimeisnotnecessarywhenswitchingfromasource
thatislowerinprioritytoonethatishigher.Therefore,switchingfromalowerpriorityinputto
ahigherpriorityinputwillhappenalmostimmediately.