2 Installation
The ACTpro-120 door station is for indoor installation only and must be installed as permanently connected
equipment.
An external AC disconnect device must be fitted. Before installation ensure that the AC supply to the
ACTpro-120 door station is disconnected.
AC power should be connected to the ACTpro-120 door station by a licensed electrician in accordance
with local/national codes.
2.1 Mounting
Mount the ACTpro-120 door station directly onto the wall with the supplied screws. The keyed mounting
hole should be screwed first to the wall to aid the mounting.
The unit should be installed in a ventilated area that allows for accessibility after installation.
2.2 AC power up
1. Attach a correctly rated AC cable and fasten using the cable tie.
Use an approved external AC disconnect device.
2. Apply AC power.
3. Check the AC OK LED is on and measure the +12V output.
© Vanderbilt 2020 7 A-100661
29.06.2020
To Next Page
Loading...
