2.3 AC power up (USA)
1. Attach a correctly rated AC cable and fasten using the cable tie.
2. Use an approved external AC disconnect device.
3. Apply AC power. Check the AC OK LED is on and measure the +12V output.
2.4 Battery insertion
1. Disconnect the AC.
2. Ensure the battery has enough charge to supply the load.
3. Connect the red battery lead to the + battery terminal and the black lead to the – terminal.
4. Apply the AC power and check the AC OK green LED is illuminated.
5. Remove the AC power and check that ON BATTERY amber LED is illuminated.
If the amber LED is illuminated the battery is now supplying the output.
6. Re-apply the AC power.
The AC OK LED will illuminate and the ON BATTERY LED will extinguish.
ACTpro-120 – Installation and Configuration Instructions Installation
© Vanderbilt 2020 8 A-100661
29.06.2020
To Next Page
Loading...
