Vanderbilt CD30 Codoor User Manual

Programming
15
Vanderbilt International (IRL) Ltd.
05.2016
10 Programming
10.1 Set Group code
Up to nine 4-digit codes can be programmed into the CD30. The ninth code can
also be used to unlock/lock the door.
10.1.1 Enter Group code
NOTE
If you have entered the wrong Axx command (e g in step 3 below) you can abort the command and
exit to Administrator mode by pressing A again.
Nine 4-digit Group codes can be set. Each Group code needs to be assigned a
code number (1-9).
Note that the code 0000 cannot be used as group code because it is used for
deleting existing group codes. See 10.1.3 Delete Group code.
1. Press B.

2. Enter the 6-digit Administrator code. See section 8 Change Administrator
code.

3. Press A21.
 The buzzer sounds a confirm tune.

4. Enter the desired 1-digit code number (1-9).
 The buzzer sounds a confirm tune.

5. Enter the desired 4-digit Group code.
 The buzzer sounds a confirm tune.

6. To set another Group code, follow steps 4-5.
7. Press B to enter the Administration mode.
8. Press B to leave the Administration mode.
Codes
Code 1: Code 4: Code 7:
Code 2: Code 5: Code 8:
Code 3: Code 6: Code 9:

Vanderbilt CD30 Codoor Specifications

General

Brand	Vanderbilt
Model	CD30 Codoor
Category	Locks
Language	English