Vanderbilt CD30 Codoor - Erase memory

Erase memory
18
Vanderbilt International (IRL) Ltd.
05.2016
11 Erase memory
In cases where the CD30 is moved to another door (with new users), old codes
should not remain. The best way to ensure this is to erase the memory.
1. Remove the CD30 from the door.
2. Press and hold the reset button on the back of the CD30 for at least 2
seconds.
 The buzzer sounds a confirm tune.

Fig. 4 Reset button on the back
3. Press 112186.
 The buzzer sounds a confirm tune.
 The buzzer sounds a warning tone to alert that you are about to erase the
memory.

4. Press 112186.
 The buzzer sounds a confirm tune.

 The memory is erased.
 The CD30 is in default mode with the following default settings:
– Administrator code: 112233
– The Administrator code can also be used for unlocking the door.
– All memory locations are empty.
– Buzzer on.