from 1/2/3/4/5 min and OFF.
-IR LED: Default setting is ON, you can choose to turn on/off the infrared
light.
-REC Status Light: Default setting is ON, you can choose to turn on/off the
REC Status Light.
-G-Sensor: Select the level of G-sensor you need, and you can set 3
directions (Front & Back/Left & Right/Up & Down). The G-sensor value in
each direction can be selected as 1/2/3/4/5/Off. The higher the sensitivity
level, the easier it is to trigger emergency recording. G-sensor is the most
sensitive when set to 5.
-Audio Recording: The default is ON, you can set the recording ON /OFF.
-Parking Mode: You can swipe up and down the screen to select the
parking mode you need, including Collision Detection/ Motion Detection/
Low Bitrates Recording/ Low Frame Rate Mode / OFF.
-Exposure: The default value is +0.0. This option can adjust the exposure
level of the front, cabin and rear camera separately.
Front: +2.0, +1.6, +1.3, +1.0, +0.6, +0.3, +0.0, -0.3, -0.6, -1.0, -1.3, -1.6, -2.0
Cabin: +2.0, +1.6, +1.3, +1.0, +0.6, +0.3, +0.0, -0.3, -0.6, -1.0, -1.3, -1.6, -2.0
Rear: +2.0, +1.6, +1.3, +1.0, +0.6, +0.3, +0.0, -0.3, -0.6, -1.0, -1.3, -1.6, -2.0
-Number Plate: After setting, your license plate number can be displayed
in the recorded video.
-Stamp: Enable or disable the watermark stamp of the video and photos.
The watermark stamp includes date and time label, VANTRUE label,
license plate number, GPS location information, speed label. All enabled
by default.
-Rotate Display: Default is off. You can choose the upside-down display
of the front + cabin screen, or the upside-down display of the rear
camera. If turned on, the video screen will be reversed 180 degree.
-Time Lapse: The default value is disabled. You can choose to enable
1FPS/5FPS/10FPS/15FPS.
-GPS Setting: GPS is enabled by default. This option can set GPS on and
- 15 -
To Next Page
Loading...
Need help?
General
