Vantrue S2 - Files

-Device Sound: Set the volume of the device. The default volume level is
3, the lowest is 0, and the highest is 5.
-Prompt Tone: According to different situations, the dash cam is set with 5
kinds of prompt tones, which are power-on/off sound, button tone, lock
tone, formatting tone, and abnormal recording tone. All prompt tones
are turned on by default.
-Frequency: Different countries have different frequency, in order to
avoid affecting the video, you can choose 50Hz or 60Hz frequency
according to different regions.
-System Info: Check the current model, firmware version and Vantrue
official website.
-Default Setting: Reset the device back to factory settings.
C. Files
Review and delete videos stored in file folders.
-Event: Critical event videos detected by G-Sensor activity or manually
locked by user.
The file name format is 20210128_140633_0008_E_A.MP4
-Normal: Standard videos recorded. This folder saves loop recording
video, parking mode video, and time-lapse video. The file name format
of Loop Recording video is 20210128_140633_0008_N_A.MP4; the file
name format of Parking Mode video is 20210128_140633_0007_P_A.MP4;
the file name format of Time-Lapse video is
20210128_140633_0006_T_A.MP4.
-Photo: Snapshot file.
-All: All the standard videos and critical event videos were recorded.
Note: The suffix A represents the files recorded by the front camera, the
suffix B represents the files recorded by the cabin camera, and the suffix
C represents the files recorded by the rear camera. Standard files are
stored in the "Normal" folder.
- 17 -