BDR-1200
2.5.6 Problems and troubleshooting
Problem Cause Solution
Cutting discs are not spinning The engine is not running Start the engine
The disc drive clutch lever is not pressed Press the lever
Insufficient belt tightening Adjust the tightening pulley
Broken belt Exchange the belt with a new one
Fallen belt Mount the belt
Other defect Visit the service center
The cutter does not move The engine is not running Start the engine
Wheel drive clutch lever is not pressed Press the lever
Insufficient belt tightening Adjust both tightening pulleys
Broken belt Exchange the belt with a new one
Fallen belt Mount the belt
Other defect Visit the service center
Engine does not start There is no petrol in the tank Refuel
Petrol feed is closed Open petrol feed
Other defect Visit the service center
Brake does not work There is no axial clearance in the Bowden cable, the cable is tight Adjust the brake
Cam is hard to move Lubricate
Brake lining has deteriorated – impossible to adjust the brake Visit the service center
Impossible to stop the cutter Tightening pulley does not come back Lubricate
Tight Bowden cable; bended Bowden cable Lubricate, or exchange Bowden cable
Wheel drive pulley spring is broken Exchange it with a new one
When using the directional
brakes, the machine does not
turn
Tight Bowden cable; bended Bowden cable
Loose wire
Broken wire
Worn out, damaged or greasy lining
Lubricate, or exchange Bowden cable
Adjust the lever pace
Replace the cable
Visit the service center
Other defect Visit the service center
Directional brakes keep slacken
up
Cam does not return
Cable return spring is broken
Tight Bowden cable; bended Bowden cable
Other defect
Lubricate the cam pin
Replace the cable
Lubricate, or exchange Bowden cable
Visit the service center
Impossible to stop the cutting
discs
Tightening pulley does not come back Lubricate
Control levers do not come back Tight brake cable; bended brake cable Lubricate, or exchange brake cable
Return spring is broken Replace it with a new one
Other defect Visit the service center
Other defect Visit the service center
Table 8: Problems and troubleshooting
29
To Next Page
Loading...
