BDR-1200
2.5.7 Storage
Before end-of-season storage clean any dirt or plant remains from the cutter. Prevent all unauthorised persons from accessing the cutter. Protect the
cutter from climatic influences, but do not use airtight protection, which can cause higher corrosion.
Check that the blades are intact and sharpen them (if damaged, exchange them).
We strongly recommend:
➢ Mothball the blades on the cutting disc..
➢ Remove all dirt and plant remains
➢ Repair damaged places on colour parts.
➢ Empty petrol tank and carburettor (for further instructions see engine user manual).
➢ Carry out seasonal lubrication of the cutter according to Table 6.
➢ Check tyre pressure, and fill the tyres to MAX level.
2.5.7.1 Machine washing and cleaning
Follow local laws protecting streams and other water resources from pollution and chemical contamination when cleaning the cutter.
Never wash the engine with a stream of water! The electrical equipment of the engine might be damaged on starting the engine.
Do not use pressure washers for cleaning the cutter.
2.5.8 Cover and machine disposal after its service life termination
You are required to carry out the package disposal after unwrapping the cutter, following national waste laws and regulations.
We recommend to follow these instructions when disposing of the machine after its service life termination:
➢ Dismount all machine parts that can still be used.
➢ Empty oil from transmission box and engine into an appropriate tank, and hand it in at a collection point
56
.
➢ Dismount plastic and coloured metals.
➢ The dismantled machine remainder and the dismounted parts are to be disposed according to national waste laws and regulations.
2.5.9 Instructions for ordering spare parts
This user manual does not include a list of spare parts. The latest version of our catalogue can be downloaded from our web pages. If you do not have
Internet access, you can order the catalogue in printed form against COD. In order to identify your machine properly you need to know its Type, Order
Number (CN°) and Identification Number (In°). These are given on the nameplate of your machine, on the box or on the warranty certificate. It is only
possible to find proper spare part designation with this information.
Field Description
Type Machine type designation. (BDR-1200)
In° Unique manufacturer identification number. (1 0008 00 001)
CN° Trade (ordering) number. (4236)
N° Serial number (year of manufacture behind it). (00526/2008)
Table 9: Nameplate - example
2.6 Manufacturer address
VARI,a.s. Phone: (+420) 325 607 111
Opolanská 350 Fax: (+420) 325 607 264
Libice nad Cidlinou (+420) 325 637 550
289 07 Czech Republic E-Mail: vari@vari.cz
Web: http://www.vari.cz
56 The place of handover will be advised to you by a competent authority.
30
To Next Page
Loading...
