F-550
Problem Cause Solution
Engine won’t start No gasoline in the tank Fill the tank with gasoline
Fuel supply is closed Open the fuel supply
Other defect Contact the service centre
Brake does not work No axial clearance in cable, the cable is tight Adjust the brake
The brake cam is stiff Lubricate the cam
Lining is worn – brake cannot be adjusted Contact the service centre
Machine cannot be stopped The tensioner does not return Lubricate
The wire in the Bowden cable is stiff, Bowden cable bent Lubricate or replace Bowden cable, as necessary
Work tool cannot be stopped The tensioner does not return Lubricate
Control levers do not return The wire in the Bowden cable is stiff, Bowden cable bent Lubricate or replace Bowden cable, as necessary
Broken return spring Replace with new spring
Other defect Contact the service centre
Other defect Contact the service centre
Table 8: Problems and troubleshooting
2.5.8 Storage
When storing for extended periods (e.g. after a season), clean the machine from all impurities and plant remnants. Prevent access of
unauthorized persons to the machine. Protect the machine against weather influences, but do not use air-tight protection due to increased
corrosion.
We recommend that you have the machine prepared for the upcoming season in one of the authorized service centres.
The service network is fully busy before the season.
We recommend, in particular:
To preserve worn places on the work tool.
Remove dirt, dust, and plant remains from the machine.
Repair damaged areas on painted parts.
Drain the gasoline from the fuel tank and the carburettor (additional instructions included in the engine operating
manual).
Lubricate the machine as recommended in
Table 6
.
Check the tyre pressure and inflate the tyres toMAX pressure.
2.5.8.1 Washing and cleaning the machine
When cleaning and washing the machine, follow all valid provisions and laws for protecting streams and other water resources from
pollution or contamination by chemicals.
Never wash the engine using a stream of water! The engine electrical equipment could be damaged when starting.
Do not use a high pressure washer!
2.5.9 Disposing of packaging and the machine after service life
After unpacking the machine, you are obligated to dispose of packaging according to national laws and waste handling
regulations.
We recommend that you follow the procedure below when disposing of the machine after the service life has been reached:
1) Disassemble all of the parts from the machine that can be reused.
2) Drain the engine and gearbox oil into a suitable closed container and submit to the waste collection site
73
.
3) Remove parts made from plastic and non-ferrous metals.
4) Dispose of the disassembled remainder of the machine and parts according to national laws and waste disposal regulations.
2.5.10 Directions for ordering replacement parts
This manual does not include a list of replacement parts.
To properly identify your machine, you must know your Model (Type), serial number (№), and order number (C№) specified on the
index plate, the box, or on the warranty card. Only after knowing this information will you be ensured of receiving the correct replacement
part from your retailer.
73
The repository location is provided by respective local authorities.
29
02/2013
To Next Page
Loading...
Need help?
General
