F-550
See the picture at the chapter 4 .
1) Nuts
2) Blade carrier
3) Work tool - blade
4) Screw
5) Center screw
1) Gearbox cover
2) Bottom gearbox cover
3) Plastic nut
4) Foot / tab
Fig. 5: Cutting width Fig. 6: Work tool mounting Fig. 7: Rear covers
Fig. 8: Cutting height Fig. 9: Higher speed Fig. 10: Lower speed
Fig. 11: Drive clutch and brake Fig. 12: Bowden cable adjustment I Fig. 13: Wheel drive clutch
Fig. 14: Bowden cable adjustment II Fig. 15: Gearbox belt
Fig. 16: Belt route
<<< Position on machine
Fig. 17: Sticker – Forbidden Area
Fig. 19: Combined sticker
Position on machine >>>
Fig. 18: Sticker – direction of turning
Position on machine >>>
Fig. 20: Sticker
Position on machine >>>
Fig. 21: Sticker
Fig. 22: Sticker – speed selection
31
02/2013
To Next Page
Loading...
