23
TRACK / COUNT-UP OPERATION
GETTING STARTED
TRACK CLOCK OPERATION
Put the scoreboard into “TRACK” mode. Make sure the “TRACK” keypad insert is in the controller.
NOTE: In “TRACK (COUNT UP)” mode, when the clock is started the time will be display in minutes
and seconds. The 1/10’s and 1/100’s of a second will be blanked out until the clock is stopped, at
which time the 1/10’s and 1/100’s of a second will be display in the “GUEST SCORE” display.
STARTING / STOPPING THE CLOCK
To start the clock, press the “START/STOP CLOCK” key. To stop the clock, press the “START/STOP
CLOCK” key.
LAPS / LAP TIME
To view the “LAP TIME” while allowing the clock to continue counting internally, press the “START/
STOP LAP” key. To return the clock to counting, press the “START/STOP LAP” key again.
To increase the “LAP” indicators, press the “LAPS” key.
OFFICIAL TIME / TIME ADJUSTMENT
With the clock stopped, the “1/100” key may be used to adjust the clock in order to display the
ofcial time. The clock will be increased by 1/100 of a second each time the “1/100 TIME” key is
pressed.
To subtract 1/100 of a second from the clock, stop the clock by pressing the “START/STOP CLOCK”
key, then press the “COUNT DOWN” key quickly followed by the “1/100” key.
To Next Page
