VAT 29 Series User Manual

13 pages

To Next Page

Installation, Operating & Maintenance Instructions

Series 29, DN 25 - 50 (I.D. 1" - 2")

VAT Vakuumventile AG, CH-9469 Haag, Switzerland

Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com

257676ED

2006-05-11

1/13

Angle & Inline Valve

with soft-pump function

with pneumatic actuator,

single acting with closing spring (NC)

This manual is valid for the valve ordering number(s):

Angle valves:

29028-KA/H/E/11/21/31/41

29032-KA/H/E/11/21/31/41

29034-KA/H/E/11/21/31/41

Inline valves:

29128-KA/H/E/11/21/31/41

29132-KA/H/E/11/21/31/41

29134-KA/H/E/11/21/31/41

The fabrication number is indicated on each product as per the label

below (or similar):

made in Switzerland

Fabrication No.:

patented

. .

. . .

–

. . . .

–

. . . . / . . . .

–

. . . . . .

Fabrication number

Explanation of symbols:

Read declaration carefully before you start any other

action!

Keep body parts and objects away from the valve

opening!

Attention!

Hot surfaces; do not touch!

Product is in conformity with EC guidelines,

if applicable!

Loaded springs and/or air cushions are potential

hazards!

Disconnect electrical power and compressed air

lines. Do not touch parts under voltage!

Wear gloves!

Read these «Installation, Operating & Maintenance Instructions» and the enclosed «General

Safety Instructions» carefully before you start any other action!

Questions and Answers:

E
Emily McgrathJul 27, 2025
What to do if VAT 29 Series valve does not open?
- J
  Jennifer GonzalezJul 27, 2025
  If the VAT Control Unit valve isn't opening, check the power and compressed air supply. Ensure the correct voltage is connected. Also, make sure the correct air pressure is connected.