21
To turn off the WiFi function, you need to move the switch slider to the “off ”position. After turning off the
WiFi function, the device cannot transmit data through the network.
3.3.6.2 LAN setting
Plug the head end of the network cable into the Ethernet interface of the device, On the area of LAN setting,
Enter a valid IP address to connect to the network.
After the network is connected normally, the network connection symbol appears in the status bar of
the screen
To turn off the LAN function, you need to move the switch slider to the “off ”position. After turning off the
LAN function, the device cannot transmit data through the network.
Note: The network of the device is only connected to the private LAN. When connecting to the network, you
need to know the security of the private network in advance. The update of the network settings needs to
confirm the reliability. The unreliable network will cause a certain risk of data loss or function failure of the
device,
3.4 After Use
3.4.1. Disconnect the Vathin endoscope from the product. For information on how to dispose of the Vathin
endoscope, refer to its user's manual.
3.4.2. Press and hold the power button for 3 seconds to turn off the product, and disconnect the power cable.
3.4.3. Clean and disinfect the product.
CHAPTER IV CLEANING, DISINFECTION, STORAGE
AND DISPOSAL
The product should be cleaned and disinfected before and after each use. It is recommended to clean and
disinfect the product according to the following instructions before and after use. Vathin Medical has
validated these instructions according to AAMI TIR 12 and 30. Any deviations from the instructions shall be
assessed properly to determine its effectiveness and potential adverse consequences to ensure that it
continues to achieve its intended purpose.
You should take the following steps to clean and disinfect the product according to good medical practices:
4.1 Cleaning
1. Prepare the cleaning solution by using the standard enzymatic detergent prepared according to the
manufacturer's recommendations. Recommended detergent: enzymatic, mild pH of 7–9, and low foam
(Enzol or equivalent).
2. Dip the sterile gauze into the enzyme solution and ensure that the gauze is moist without dripping.
3. Use the wet gauze to thoroughly clean the buttons and housing of the product. Well protect the product
from being wet to avoid damage to its internal electronic components.
4. Use a sterile soft brush dipped in enzyme solution to clean the buttons until all dirt is removed.
To Next Page
Loading...
