VDIAGTOOL V210 - Important Safety Information; Using the Automotive Short and Open Finder; Specifications

Automotive Short And Open Finder
4
Automotive Short And Open Finder
1
For use only with DC voltage. Do not connect to circuits exceeding 42 volts DC under any
circumstances.
Exceeding the limits listed above when using this tool kit, or not obseing the precautions
listed above can expose you to physical inju and permanently damage your tool kit and
pas and components of the vehicle under test.
◆ Do not use on AC voltage.
◆ Do not use on any circuit directly or indirectly connected to AC lines or any other AC
power source.
◆ Do not use with any component or pa of the ignition system.
◆ Before using this device check the vehicle’s electrical wiring and disconnect any pa or
subsystem sensitive to voltage and current pulses such as air bags, electronic control
modules, etc.
◆ Always follow the instructions and procedures indicated in the vehicle’s seice manual
before attempting to disconnect any pa or subsystem of the electrical circuit.
1. Impoant Safety Information
2. Using The Automotive Sho And Open Finder
2.1 Specications
V210 Transmitter
V210 Receiver
Operating Voltage
Working Current
Operating Temperature
Storage Temperature
Max Operating Relative Humidity
Max Storage Relative Humidity
Power Source
Material
Dimensions (L × W × H)
Weight
Probe Length
Power Source
Working Current
6 - 42V DC
0.2 - 0.5A
0°C to 60°C (32°F to 140°F)
-40°C to 70°C (-40°F to 185°F)
80%
50%
9V (Powered by 9V Batte)
ABS
73.6 × 61 × 22.15mm (2.89 × 2.40 × 0.87 in)
63g(0.138 lbs)
172mm(6.77 in)
9V (Powered by 9V Batte)
0.2-0.5A