VDO Cyclecomputing C05 - Set-up Mode

This button / key has several functions.
All functions of the button / key are outlined in the chart below.
Your display Button / Key to Length of pushing What is going on?
indicates following be pushed the button / key
information
DST-ODO-CLK-ATM push MODE key brief (0.1 sec) next information from DST or ODO or ATM
is indicated.
ODO push MODE key long (5 sec) enter set-up mode for wheelsize and odometer
CLK push MODE key long (5 sec) enter set-up mode for clock
DST push MODE key long (5 sec) DST and ATM are simultaneously reset to ZERO
Watch out: To avoid resetting DST and ATM by mistake, thoroughly check the information in display
before you push the MODE key for 5 sec.
5. Set-up mode
Your VDO CYTEC C 05 features the following set-up procedures Watch out:Once the battery is properly
fitted, your VDO CYTEC C 05
wheelsize = WS set-up starts out of ODO in display immediately changes into
clock = CLK set-up starts out of CLK in display set-up mode
odometer = ODO set-up starts out of ODO in display (see also chapter 5.3).
9
GB