5.3 Entering your wheelsize / entering odometer
After initially installing the battery or after a battery change, your VDO CYTEC C 05 automatically switches
into set-up mode for wheelsize and odometer. Start with Step 3.
You might as well enter the set-up mode for wheelsize and odometer at any time by proceeding as follows:
Step 1: Call ODO information in your display.
Step 2: Press MODE button for 5 sec. Display shows an alternating flashing symbol for KMH and MPH.
Step 3: By pressing the MODE button you can choose whether you want MPH or KMH readout on your
display. Now you have determined whether your VDO CYTEC C 05 is either measuring in
kilometers or miles.
Step 4: Once you have chosen your measuring unit, the wheelsize value is displayed. After a battery
change, the default value (2124) comes up. In case you have entered wheelsize set-up from
ODO (see step 1),the last value entered will come up.
In case you want to use the default value (2124) after a battery change,
just press the MODE button within 2 seconds.
The default is then automatically set up and the computer returns to regular mode.
In case you wish to enter the precise wheelsize you have measured yourself (i.e. 2257),
please proceed with step 5.
GB
12
To Next Page
Loading...
