GB
12
5.3 Entering your wheelsize / entering odometer
After initially installing the battery or after a battery change, your VDO CYTEC C05+ automatically switches
into set-up mode for wheelsize and odometer.
Start with Step 3.
You might as well enter the set-up mode for wheelsize and odometer at any time by proceeding as
follows:
Step 1: Call ODO information in your display.
Step 2: Press MODE button for 5 sec. Display shows an alternating flashing symbol for KMH and MPH.
Step 3: By pressing the MODE button you can choose whether you want MPH or KMH readout on your
display. Now you have determined whether your VDO CYTEC C05+ is either measuring in kilometers or
miles.
Step 4: Once you have chosen your measuring unit, the wheelsize value is displayed. After a battery
change, the default value (2124) comes up. In case you have entered wheelsize set-up from ODO
(see step 1), the last value entered will come up.
In case you want to use the default value (2124) after a battery change, just press the MODE button
within 2 seconds.
The default is then automatically set up and the computer returns to regular mode.
To Next Page
Loading...
