VDO Cyclecomputing MC1.0 - Entering (Programming) the Wheelsize(S)

GB
MC
1.0
10
2.5.2 Entering (programming) the wheelsize(s)
Step 1:  By pressing MODE 1 call TRIP DIST in your display.
Step 2:  Press MODE 1 for 3 sec. In the upper part of the display you see "WS1" and "KMH" or "MPH" flashing. The lower part of the display alternately 
shows "ENTER MTRIC SYSTM" and "KMH" or “ENTER ENGL SYSTM” and “MPH”.
Step 3:  With MODE 2 you choose whether you want kilometers=KMH oder miles=MPH as a measuring unit.
Step 4:  Once the conversion of KMH or MPH has been chosen, you proceed by briefly pressing (0.1 sec) MODE 1. The lower part of the display now 
alternates "ENTER WHEELSIZE1" and 2155. The last number "5" flashing.
Step 5:  With MODE 1 and MODE 2 you enter your measured wheelsize 1 (bike1). MODE 2 increases the flashing number MODE 1 jumps to the next number, 
see set-up mode.
Step 6:  Once you have entered the last number of wheelsize 1 and press the MODE 1 button, the computer automatically jumps to the setup mode for 
wheelsize 2. The lower part of the display alternately shows "ENTER WHEELSIZE2" and 2000 with the last number "0" flashing.
Enter your wheelsize 2 as described in Step 5.
Step 7:  Once you have entered wheelsize 2, press MODE 1 for 3 sec to exit set-up mode. The computer will return to displaying TRIP DIST.
Warning: Exiting setup procedure before having completely entered the precise wheelsize may lead to faulty readouts.
P10