11
English
MAIN FUNCTIONS
Switching On/Off
Press POWER to switch the set ON or OFF.
Selecting a source
Your car radio is designed for different types of
sources You can select them by a short press
on the SOURCE key.
Press the SOURCE key to display and select the
source you want to play.
- Tuner (radio),
- CD/MP3,
- CD Changer (CDC),
- Auxiliary.
Controlling the volume
a-Volume
Use the keys +/- to adjust the volume: the
volume automatically increases or decreases if
the SDVC connection has been installed and
selected (see Installation in page 6).
Note : Make sure that you can always hear the
traffic (horns, sirens, etc.).
b-Mute
1- Press MUTE, to mute the audio system.
2- Press MUTE again if you want to restore
the last audio source heard.
Note 1 : In this state, the following audible
events can occur: Announcements (Traffic,
News, Navigation), Telephone calls, Alarms.
Note 2 : Some cars, mobile phones or navi-
gation system can automatically interrupt the
audio output if they are linked to the set.
c-Wake up
If your mobile phone is connected to the car
radio (see Connector D1 in page 7), you will
not miss any incoming call even when the car
radio is switched Off because it will
automatically "wake up" upon detecting a call.
Displaying Source Informations
Short press on the DISPLAY key to display
informations (track, time, info line, etc.) about
the chosen source (Tuner, CD/MP3,CDC).
SAM MENU
The SAM menu allows you to configure the
main options of your car radio.
1- Long press the MUTE key to get to the SAM
MENU (see options in cover pages).
2- Use the
keys to select an option.
3- Use the
keys to set the option value.
4- Press ESC to enter the value.
Defining the Scan Time
With this function, you can define the time
before jumping to the next station (Tuner) or
track (CD/MP3,CDC).
1- Long press MUTE.
2- Select SCAN TIME using the
keys.
3- Use the
keys, to select a number of
seconds (10s by default).
4- Press ESC to enter the value.
Using radio when not running
This function allows the use of the car radio
when the vehicle is not running (only if the A7
wire is connected to a permanent supply).
1- Long press MUTE.
2- Select LOGIC with the keys.
3- Use the
keys, to select ON (default value)
or OFF.
4- Press ESC to enter the value.
Note : The set will turn OFF after 1 hour or if
the battery voltage becomes < 9 volts.
Setting an Auxiliary Equipment
This function enables or disables an auxiliary
device connected to the set.
1- Long press MUTE.
2- Select AUXILIARY using the
keys.
3- Use the keys, to select ON (default value)
or OFF.
4- Press ESC to enter the value.
AN2001-2L-Eng.pm7 11/20/02, 3:32 PM11
To Next Page
Loading...
