VDO CD 4203 - Tuner Initialisation Menu; Selecting the Scanning Type

15
English
Saving a station in memory
You can save up to 30 stations on the FM and
MW wavebands and 10 stations on LW
wavebands.
1- Short press ENTER.
2- Select SAVE IN with the
keys.
3- Use the
keys to select a memory number.
4- Press ENTER to enter the value.
Note : It is not possible to manually save
stations from the FM AST or MW AST bands.
Moving to the Tuner Init Menu
Use this function to get to the Tuner Init Menu.
1- Short press ENTER.
2- Select TUNER INIT with the
keys.
3- Press ENTER to get to the tuner initialisation
menu (see next menu).
Note : You can have access to this menu by
long pressing the ENTER key.
Moving to the SAM Menu
Use this function to get to the SAM Menu.
1- Short press ENTER.
2- Select SAM with the
keys.
3- Press ENTER to get to the SAM Menu.
TUNER INITIALISATION MENU
1- Press the SOURCE key to select TUNER
2- Long press ENTER to get to the TUNER INIT
MENU (see options in cover page).
3- Use the
keys to select an option.
4- Use the keys to set the option value.
5- Press ESC to enter the value.
Selecting the Scanning Type
On your current waveband and for a scan time
defined, you can select the scanning type:
stations or presets stations.
1- Long press ENTER.
2- Select SCAN with the
keys.
3- Use the keys, to select:
- FREQ to review all the stations on the
current waveband,
- PRESETS to review all the pre-selected
stations on the current waveband.
4- Press ESC to enter the value.
Note : You can modify the scan time in the
SAM menu.
Selecting the search level
With this function, you can select the search
level (in FM only).
1- Long press ENTER.
2- Select SEARCH LVL with the
key.
3- Use the keys to select:
- DISTANT (default value) to search for all
receivable stations
- LOCAL to search for strong stations first
and then weak stations.
4- Press ESC to enter the value.
Note : After a while, the function returns to
Distant mode (default value).
Selecting the Continent Area
With this function, you can select the continent
area for tuning.
1- Long press ENTER.
2- Select TUNER with the
keys.
3- Use the keys to select the continent: USA,
EUR, ASIA.
4- Press ESC to enter the value.
Selecting the region mode
With this function, you can select the region
mode.
1- Long press ENTER.
2- Select REGIONAL with the
keys.
3- Use the keys to select:
- AUTO to switch programme when the
next signal is stronger
- ON to maintain regional programme
- OFF to directly switch to the programme
of the next region
4- Press ESC to enter the value.
Switch off MW or LW
With this function, you can switch off MW or
LW when not in used.
1- Long press ENTER.
2- Select MW or LW with the
keys.
3- Use the keys to set the function: ON or
OFF.
4- Press ESC to enter the value.
AN2001-2L-Eng.pm7 11/20/02, 3:32 PM15