VDO CD 4203 - Speed Calibration, PDC, and Parameter Reset

23
English
Switching the Frost Warning
Use this function to set the frost warning: as
soon as the temperature becomes lower than
3 °C, a warning is generated.
1- Long press COMPUTER.
2- Select FROST WARN with the
keys.
3- Select ON or OFF with the
keys to acti-
vate/deactivate the function.
4- Press ESC to enter the value.
Note : You can use this function only if the
temperature sensor is connected.
Selecting Speed Units
Use this function to select the unit for dis-
playing the speed.
1- Long press COMPUTER.
2- Select SPD UNITS with the
keys.
3- Use the
keys to set the units: Km/h or
mph.
4- Press ESC to enter the value.
Setting the Speed Warning
Use this function to set the speed value for
warning, if you exceed this value.
1- Long press COMPUTER.
2- Select SPEED WARN with the
keys.
3- Use the keys to select:
- OFF to deactivate speed warning.
- 50 km/h to 250km/h (31mph to 156
mph) to set the speed warning.
4- Press ESC to enter the value
Note : You can use this function only when
the speed signal is connected and calibrated
(see SDVC and Calibrating the speed in pages
6 and 10 respectively).
Setting the Break Warning
Use this function to set a break warning. So, if
you drive more than 2 hours, a warning will be
displayed every 15 minutes.
1- Long press COMPUTER.
2- Select BREAK WARN with the
keys.
3- Use the keys to select ON or OFF to
activate/deactivate the function.
4- Press ESC to enter the value.
Switching the Battery Warning
Use this function to set a battery value for
warning: so, if the battery voltage is below this
value, a warning will be displayed.
1- Long press COMPUTER.
2- Select BAT. WARN with the
keys.
3- Use the
keys to set the value.
4- Press ESC to enter the value.
Selecting Infos to be displayed
Use this function to set what will be displayed
on the first line after pressing the DISPLAY key.
1- Long press COMPUTER.
2- Select INFO LINE with the
keys.
3- Use the keys to select the information to
be displayed: temperature, clock, avg
(average) speed, max speed, cur (current)
speed, total time, trip time, total dist
(distance), trip dist (distance), battery.
4- Press ESC to enter the value.
Starting the Speed Calibration
Use this function to start speed calibration.
1- Long press COMPUTER.
2- Select SPD CALIB with the
keys.
3- Press ENTER to start the calibration.
Note: See Calibrating the Speed in page 10.
Setting PDC
Use this function to activate/deactivate PDC.
1- Long press COMPUTER.
2- Select PDC with the
keys.
3- Use the keys to set the function : ON or
OFF.
4- Press ESC to enter the value.
Resetting the Parameters
Use this function to reset the Car Computer
parameters
1- Long press COMPUTER.
2- Select RESET with the
keys.
3- Press ENTER.
4- Use the
keys to select the parameter to
be reset : SPEED MAX, SPEED AVG, TRIP or
TOTAL.
5- Press ENTER to launch the reset for the
selected parameter.
6- Repeat step 4 to 5 to reset another
parameter.
AN2001-2L-Eng.pm7 11/20/02, 3:32 PM23