10
Setting a Navigation System
This function enables/disables the navigation
messages detection for the car radio.
1- Long press MUTE.
2- Select NAV with the keys.
3- Use the keys, to select NO (default
value), Mute or IN.
4- Press ESC to enter the value.
Note
: Set to IN if the Nav audio is connected
to the audio IN wires. In same case, you need
to set the navigation detection level (see your
dealer to fill in the next option).
Setting Navigation Detect Level
This function allows to configure the naviga-
tion message detection level (Nav mute wire).
1- Long press MUTE.
2- Select NAV LVL with the keys.
3- Use the keys, to select LOW (default
value) or HIGH.
4- Press ESC to enter the value.
Note
: You need to select the value according
to the type of the connected equipment.
Setting the SDVC
This function allows you to switch Off the
SDVC or to select one of the five curves in
order to adjust the sensibility of the volume
control related to the car speed.
1- Long press MUTE.
2- Select SDVC TYPE with the keys.
3- Use the keys, to set Off, curve 1, curve
2, curve 3, curve 4 or curve 5.
4- Press ESC to enter the value.
Note 11
: It is better to set this function after
calibrating the speed (see Configuration):
otherwise SDVC will be without calibration.
Note 22
: You choose a SDVC curve according
to the state of your environment noise.
Setting the Light Display Brightness
This source independent function adjusts the
brightness of light display between its min.
and max. value (1 to 10).
1- Long press MUTE.
2- Select BRIGHTNESS with the arrows.
3- Use the arrows to select a value.
4- Press ESC to enter the value.
Launching Loudspeakers Installation
Use this function to verify the installation of
your loudspeakers.
1- Short press ENTER.
2- Select INSTALL with the keys.
3- Press ENTER to launch the function: a
beep is emitted for each well installed
loudspeaker.
4- Switch OFF/ON the set.
You can set the radio stations options after
selecting the tuner source. Then by either a
short or long press on ENTER, you get two
different tuner menus (see cover pages).
Search Left/Search Right
Use the keys to scroll through the selec-
ted waveband.
Search Up/Search Down
Use the keys to scroll through the memo-
rised stations list of the waveband.
TUNER MENU
1- Press the SOURCE key to select TUNER
2- Short press ENTER to get TUNER MENU.
3- Use the keys, to select an option.
4- Use the keys to set the option value.
5- Press ESC to enter the value.
Selecting a waveband
With this function, you can select a band in a
scrolling list.
1- Short press ENTER.
2- Select BAND with the keys.
TUNER
AN 2001 2L gb.qxd 16/07/01 14:54 Page 10
To Next Page
Loading...
