Vector TCI-C Series - Temperature Input Configuration

TCI-C-Universal Controller
Doc: 70-00-0123, Date: 20091020 © Vector Controls GmbH Page 18
Universal Input configuration
Parameter Description Range Default
1u 00
Input signal type:
0 = input not active
1 = Analog input: 0…10V or 0…20mA
2 = Analog input: 2…10V or 4…20mA
3 = Passive temperature NTC – Tn10
0 - 3 3
1u 01
Signal display minimum value
-50…205 0
1u 02
Signal display maximum value
-50…205 100
1u 03
Range of universal inputs (For analog inputs only)
0 = x1
1 = x10
2 = x100
0 – 2 0
1u 04
Unit of universal input (For analog inputs only):
0 = no unit
1 = %
2 = °C /°F
3 = Pa
0 – 3 0
1u 05 Samples taken for averaging control signal 0…100 10
1u 06 Calibration Range dep 0
1u 07 Alarm 1: Enable alarm for lower limit
OFF = Disabled
ON = Enabled
OFF, ON OFF
1u 08 Alarm 1 low limit -40…215 °C 5°C (40°F)
1u 09 Alarm 2: Enable alarm for upper limit
OFF = Disabled
ON = Enabled
OFF, ON OFF
1u 10 Alarm 2 high limit -40…215 °C 50°C (122°F)
1u 11 Alarm 1 and 2 Hysteresis for alarm setbac
k
0…100 ° 5°C (10°F)
Temperature Input configuration
Parameter Description Range Default
1t 00
Temperature input enabled
ON, OFF OFF
1t 01
Signal display minimum value
-50…205 -50
1t 02
Signal display maximum value
-50…205 200
1t 03 Samples taken for averaging control signal 0…100 10
1t 04 Calibration -10.0…10.0 0
1t 05 Alarm 7: Alarm for lower limit of temperature input of LP1
OFF = Not active
ON = Active
OFF, ON OFF
1t 06 Alarm 7 low limit of temperature input -40…215 °C 5°C (40°F)
1t 07 Alarm 8: Alarm for upper limit of temperature input of LP1
OFF = Not active
ON = Active
OFF, ON OFF
1t 08 Alarm 8 high limit of temperature input -40…215 °C 50°C (122°F)
1t 09 Alarm 8 Hysteresis for alarm setback 0…100 ° 5°C (10°F)