Vector VI 200 - Calibration and Parameter Configuration; Entering Calibration Mode

User Manual
Page 12 of 27
Check the total weight operation:
Press “SET” hold it then press “TOTAL” At the same time, display ”n**”,
(accumulating times) then display total weight.
There are 8 data totally. It shows the first 4 digital. then the last 4 digital
For example, the first 4 digital is”0012”, the last 4 digital is”34,56”
It means the actual weight is “1234.56”
At TOTAL (accumulate) mode, Press “TOTAL” key the indicator
show“ clrn”, it means don’t clear the total Weight, Press “
key
confirm it and exit ; if clear total weight, Press “ ” “ ”
“clrn” change to “clry” it means clear total weight display. Press “
”to
clear the the total weight and exit accumulating mode.
3.710timeshighresolutions
Press “ SET” and “TARE” key at the same time, you will get 10 times high
resolutions. And it back to normal weighing after 3 seconds.
3.8UpandLowlimitalarm
Pls. set C13= Up limit, C14=Low Limit, when the weight is over up limit,
the “HI” light will on, and indicator will make a sound to alarm.; when the