User Manual
Page 13 of 27
weight is below than the low limit, the “LO” light will on.. when the weight
is within the limit, the “OK” light is ok.
3.9Printfunction
When the data is stable, connection with printer, it will be printed after
press“
”1 second.
Note：print the gross weight when at tare mode , if the net weight is zero.
Can not print.
4 Calibration & parameter
setting
4.1Entercalibration
There have two methods to enter the setting menu:
1. when the switch” CAL” is off, Press”
” then press” at the
same time, hold it, you will enter C08-C39 setting.
2. Take out the sealing screw on the back of indicator, then press
To Next Page
Loading...