EasyManua.ls Logo

Vector VI 200 - Installation and Calibration; Load Cell Connectivity

Vector VI 200
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual
Page 5 of 27
1.4Battery
1. when you use the internal battery first timeyou should charge the battery
10-12 hours, to prevent low voltage resulted from self leakage of battery.
2. when the red battery light is on and flashesit means low battery You
should charge battery in time.
3. Charge time: 10-12 hours And it works 45 hours
4. When the battery light turns green, it means fully charged
5. If you don’t use the battery long time, take out the battery to protect the
indicator from battery leakage
6. In order to keep the battery in best using condition, it is suggest that you
fully discharge the battery every month, the method is that using the
indicator till it is automatically power off.
2. Installation and Calibration
2.1connect ionindicatorwithlo a d cell
it can connect four pcs 350load cell at most, both four and six line load
cell are ok. To make it simple, we use quick connector
Or standard plug. As belows