3.2 Device Configuration
Manual VN5610/VN5610A Version 2.0 36
Note
In order to get a working Ethernet link between the VN5610/VN5610A and another
Ethernet device, the auto negotiation has to be activated in both devices.
Alternatively, both devices can be manually configured with the same parameters
(only full duplex mode).
Please note that the Ethernet link will run in half duplex mode if one device uses
auto negotiation while the other one is manually configured. The VN5610/VN5610A
supports only full duplex mode.
Note
You can also change the Ethernet settings in the Network Hardware Con-
figuration of CANoe.Ethernet /CANalyzer.Ethernet:
Figure 21: Network Hardware Configuration
Figure 22: Network Hardware Configuration
To Next Page
Loading...